No.65,Lane 667,Chung San Rd,Seng Kung, Taichung,Taiwan
Tel:886-4-25620100~2(3 Lines)
Fax:886-4-25629657
E-mail: aidec@ms17.hinet.net |
|
|
全波型 - 電子式日光燈柔性起動器
新型專利 M281373 號柔性起動
發明專利申請中保護燈管
| 型號 Model Number |
FE-1P |
FE-2PP |
FE-4P |
FE-5P |
| 電源 Source Type |
AC 100~120V
50/60Hz |
AC 220~240V
50/60Hz |
AC 100~120V
AC 220~240V
50/60Hz |
AC 100~120V
50/60Hz |
| 操作電壓 Operating Voltage |
AC 90V~132V |
AC 175V~264V |
AC 90V~132V
AC 170V~264V |
AC 90V~132V |
| 適用燈管 Tube Type |
FL- 4~20W
FCL-22~30W
FDL-27W |
FL-10~20W |
30~40W (110V)
4~40W (220V) |
FCL-32W |
| 起動方式 Start Type |
軟起動
Soft Start |
軟起動
Soft Start |
軟起動
Soft Start |
軟起動
Soft Start |
| 整流方式 Rectifier Circuit |
全波型
Full-Wave |
全波型
Full-Wave |
全波型
Full-Wave |
全波型
Full-Wave |
| 點燈時間 Start Time |
1.3+-0.1 Sec. |
1.2+-0.1 Sec. |
0.8+-0.1 Sec. |
0.8+-0.1 Sec. |
| 脈衝電壓 Pulse Voltage |
700 V |
900 V |
900 V |
900 V |
| 預熱電壓 Preheat Voltage |
100V
Low |
100V
Low
|
100V
Low |
100V
Low |
| 預熱電流 Preheat Current |
1A
Low
|
1A
Low
|
1A
Low |
1A
Low |
| 重覆點燈 Repeated Circuit |
有
Yes |
有
Yes |
有
Yes |
有
Yes
|
| 自動復置 Auto Reset Circuit |
有
Yes |
有
Yes |
有
Yes |
有
Yes |
| 過溫保護 Thermal Protection |
有
Yes |
有
Yes |
有
Yes |
有
Yes |
| 更換保護 Change Protection |
有
Yes |
有
Yes |
有
Yes |
有
Yes |
末期燈管保護
Dying Lamp Protection |
有
Yes |
有
Yes |
有
Yes |
有
Yes |
| 點燈壽命 Life Times |
200,000次 |
200,000次 |
200,000次 |
200,000次 |
| 特性 Specification |
| * |
全波整流 Full-Wave rectification
新型螢光燈管電子起動器，採用全波式整流電路，不產生電磁干擾及避免哼聲現象。
New Type Electronic starter all use by full wave rectification, it without any electromagnetic interference and avoid hums. |
| * |
柔性起動 Soft start
電子式預熱型起動燈管，將燈絲預熱再以低電壓、低電流起動，以符合柔性起動之原理。
Electronic style preheat start tube, it will preheat for filament and start by Low voltage and low electric current to conform soft start principle. |
| * |
單脈波點燈 Single pulse wave
起動器採單一脈波點燈，單脈波可減少熱電子激發次數，進而延緩黑化、老化現象，延長燈管壽命。
Electronic Starter use by Single pulse wave, which can reduce thermal electron number and to delay Black light and maturing for extend tube life. |
| * |
重複起動 Repeat start
因外部環境(電壓低或氣溫低)造成燈絲預熱不足，無法順利點亮燈管時,可自動重複點燈。
Because exterior condition (Low voltage Or Low Temperature) to make filament not enough in that can’t light up, it can repeat light up by automatic. |
| * |
末期燈管 The last phase tube
對於末期燈管,迴路設計會自動關閉。
About the last phase tube, circuit design will be shut by automatic. |
| * |
過溫保護 Thermal Protection
起動器內含溫度保險絲，多層保護電路，確保用電安全。
The Starter is including temperature fuse, to protect circuit more to make sure safety when use the power. |
| * |
保護電路 Protect circuit
自行偵測在燈管點亮時進行更換安裝起動器,不再次產生高壓,確保安全。
When tube light up and also to set the starter up, it can detect by itself and no result High pressure again to keep safety. |
| * |
自動重置 Reset by itself
自動重置電路可使每次切換開關時,均會重新預熱計時,避免因預熱時間過短而無法將燈管點亮。
Circuit reset by itself can reset preheat clock when on off every time to avoid preheating time too short to light up the tube. |
|
|
