| Model Number |
FE-1P |
FE-2PP |
FE-4P |
FE-5P |
| Source Type |
AC 100~120V
50/60Hz |
AC 220~240V
50/60Hz |
AC 100~120V
AC 220~240V
50/60Hz |
AC 100~120V
50/60Hz |
| Operating Voltage |
AC 90V~132V |
AC 175V~264V |
AC 90V~132V
AC 170V~264V |
AC 90V~132V |
| Tube Type |
FL- 4~20W
FCL-22~30W
FDL-27W |
FL-10~20W |
30~40W (110V)
4~40W (220V) |
FCL-32W |
| Start Type |
Soft Start |
Soft Start |
Soft Start |
Soft Start |
| Rectifier Circuit |
Full-Wave |
Full-Wave |
Full-Wave |
Full-Wave |
| Start Time |
1.3+-0.1 Sec. |
1.2+-0.1 Sec. |
0.8+-0.1 Sec. |
0.8+-0.1 Sec. |
| Pulse Voltage |
700 V |
900 V |
900 V |
900 V |
| Preheat Voltage |
100V
Low |
100V
Low |
100V
Low |
100V
Low |
| Preheat Current |
1A
Low |
1A
Low |
1A
Low |
1A
Low |
| Repeated Circuit |
Yes |
Yes |
Yes |
Yes |
| Auto Reset Circuit |
Yes |
Yes |
Yes |
Yes |
| Thermal Protection |
Yes |
Yes |
Yes |
Yes |
| Change Protection |
Yes |
Yes |
Yes |
Yes |
| Dying Lamp Protection |
Yes |
Yes |
Yes |
Yes |
| Life Times |
200,000 |
200,000 |
200,000 |
200,000 |
Specification
- Full-Wave rectification
New Type Electronic starter all use by full wave rectification, it without any electromagnetic interference and avoid hums.
- Soft start
Electronic style preheat start tube, it will preheat for filament and start by Low voltage and low electric current to conform soft start principle.
- Single pulse wave
Electronic Starter use by Single pulse wave, which can reduce thermal electron number and to delay Black light and maturing for extend tube life.
- Repeat start
Because exterior condition (Low voltage Or Low Temperature) to make filament not enough in that can't light up, it can repeat light up by automatic.
- The last phase tube
About the last phase tube, circuit design will be shut by automatic.
- Thermal Protection
The Starter is including temperature fuse, to protect circuit more to make sure safety when use the power.
- Protect circuit
When tube light up and also to set the starter up, it can detect by itself and no result High pressure again to keep safety.
- Reset by itself
Circuit reset by itself can reset preheat clock when on off every time to avoid preheating time too short to light up the tube.
|
